How to Replace a Broken Samsung Galaxy S7 Edge Screen in 10 Minutes

Samsung Galaxy S7 Edge is absolutely a beast among flagship smartphones. Its curved Corning Gorilla Glass display makes for a sleek display this is harder than it seems. However, it is not absolutely immune from harm. On the off threat that you do shatter your display, you could follow the stairs indexed here to repair it quickly Samsung-Reparationer.

The special tools listed may be bought online without difficulty or even rented for an hour or two from a neighborhood mobile restore shop. You may additionally want a visual guide to help you identify the parts in case you are strange with the layout. The steps to update the broken screen of your Galaxy S7 are cited right here.

• Shut down the tool and cast off the SIM card tray.

• Heat up the again of the tool with a heat gun or hair dryer until it will become too warm to touch.

• Place a suction cup at the again of the device.

• Pry the back of the device to insert the skinny steel spudger.

• Take off the returned cover by sliding the spudger along the joints. Insert a enterprise card or gambling card to save you the again cowl from sealing again up. Do no longer use a credit card as they’re too thick. Slowly take off the back cover after the whole edge has been separated.

• Use Phillip head screwdriver to undo the 12 Phillip screws retaining down the rear housing.

• Next, use a plastic separation device to split the pinnacle plastic bracket. Remove the wireless charging pad after.

• Disconnect the battery cable, power cable, show cable, and the energy button cable.
• Use tweezers to disconnect the loudspeaker module.

• Pop off all of the antenna cables and fingerprint scanner cables.

• Disconnect the earphone connector, the front going through digital camera connector, and the proximity, and the light sensor connector.

• You can now raise up the motherboard and disconnect the charging port connector.

• Remove the rear-facing digital camera.

• When you have reached the battery, you could have to heat it up a bit to raise it up with a spudger.

• Undo the 3 screws holding the earphone jack and get rid of the jack and small board connected to it together.

• Use the warmth gun and observe some warmness at the pinnacle glass panel.

• Gently press the screen meeting to create a gap among the display screen and the front meeting. You can use the spudger however do now not insert it too deep.

• Increase the space the usage of a plastic device or enterprise card. You may must use tweezers to pull around the black adhesive.

• After the adhesive has been cleared, carefully raise the display screen from one facet.

• Replace the screen and take a look at the new screen earlier than you reinstall the opposite components.

• Now you need to go through all of the steps backwards to reinstall all the other components. Use some heat activated adhesive to stick the outer assembly together. Special glue is also to be had.

If you have enjoy tinkering with digital devices, the complete manner takes less than 10 minutes. But even a newbie can whole those steps if they observe the instructions carefully. It can be beneficial to refer to photos or maybe movies to get an idea of a way to proceed. Now remember your level of enjoy, remember to smooth and dry your arms to smooth any dust and grime. Also, make sure that the paintings floor is solid and dust unfastened.